ep

January 22, 2021

SMR Gearbox Installation
Satisfactory functionality will depend on good set up. lubrication and maintenance. as a result it is vital that the directions in the installation and maintenance leaflet. provided with each gearbox. are followed carefully. a few of the crucial elements of belt and torque-arm installation are listed under.
1. Install pulley on gearbox input shaft as close on the reducer achievable, and mount reducer on driven shaft as near to bearing as useful. failure to accomplish this may bring about extra loads within the input shaft bearings and output bearings and could lead to their premature failure.
2. Install motor and wedge belt drive with the belt pull at around 90° on the center line concerning driven and input shafts. this can allow tensioning on the wedge belt drive together with the torque arm which ought to ideally be in tension. if output hub runs anti-clockwise. torque arm must be positioned the correct.
three. lnstall torque-arm fulcrum on a rigid help in order that the torque-arm might be at somewhere around suitable angles to the center line through the driven shaft along with the torque arm situation bolt. ensure that there is adequate consider up during the turnbuckle for belt stress adjustment.
Hold shut.
Bell drive may be located in any convenient postion. in case the torque arm is usually to be utilised to tighten the belts, the drive must be at about tight angle on the line among the input and output shafts.
Bell drive could be positioned to your proper if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite route to that proven inside the illustration.
Torque arm and belt get up.
Torque arm could be mounted to the right if wanted.