Power UNITS FOR LIFT TABLE one
General Description
This power unit is made solely for that small lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit continues to be broadly utilized in the field of logistic units for instance minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed from the solenoid valve using the pace controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This electrical power unit is made exclusively for your medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve as well as pace managed through the adjustable needle valve. When the lift rises to a large positoin, however the energy supply is minimize, the lowering movement is managed from the guide override function.
Energy UNITS FOR LIFT TABLE 3
Basic Description
This electrical power unit is made solely for that huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve and also the pace managed by a pressure compensated flow control valve.
Energy UNITS FOR LIFT TABLE four
General Description
This power unit is intended exclusively for your huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve as well as speed managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the energy provide is minimize, the lowering movement is managed from the guide override perform.
Unique Notes
one. This electrical power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic parts concerned before set up of the energy unit.
3. Viscosity from the oil shoud be 15~46 cst,which need to also be clean and free of impurities.N46 hydraulic oil is advised.
4. Oil modifying is needed following the original 100 operation hrs,afterwards as soon as just about every 3000 hours.
5. The power unit shown is made to be mounted vertically.