The EP Greenhouse geared motor is a compact and lightweight reduction gear motor with an integrated limit switch system that’s ideal for assembly of a locally available electric engine. The gearbox can be used in manually-managed or climate-controlled ventilation and display systems in greenhouses. The quick and easy-to-install EP gear driver is rainproof and windproof. The geared motor has a high protection class (IP65) and can be utilized in an ambient temperature of 0-60 °C.

The low-noise geared motor for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmission means that the drive shaft is locked when the decrease gear driver is not running. The fully sealed reduction gear driver comes with an growth chamber with a diaphragm to keep carefully the gear essential oil at a minimal pressure under all conditions, even at high temps. Thanks to the use of an expansion chamber, the gearbox can be installed in any placement. There are no limitations, since there is no dependence on a bleed plug. The sealed reduction gearbox keeps the gear essential oil of the gear reducer in optimum condition for its entire operating life time. The reducer is ideal for discontinuous use, operating course s3-30%, with a maximum activation period of 25 minutes.

The Gear box reduction gear reducer has an FT85 motor assembly flange, to which a suitable IEC standard motor can easily be installed (EN 50347).

The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed in an built-in chamber and is enclosed by an impact-resistant plastic-type cover. The limit change system is obtainable and easy to adjust. The limit change system’s maximum switching range is certainly 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The geared motor has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The gear motor for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.

Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of software of 4-pole electric motor.
Protection class IP65.
May be used in ambient temps of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, maximum activation time 25 a few minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC regular motor (EN 50347).
Maximum switching range of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).